new file mode 100644
@@ -0,0 +1,50 @@
+/*
+ * linux/include/amba/dma.h
+ *
+ * Copyright (C) 2010 ST-Ericsson AB
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License version 2 as
+ * published by the Free Software Foundation.
+ */
+#if !defined(AMBA_DMA_H) && defined(CONFIG_DMADEVICES)
+#define AMBA_DMA_H
+
+/**
+ * struct amba_dma_channel_request - this struct is passed in as
+ * configuration data to a DMA engine in order to set up a certain
+ * channel for DMA transport. Anything the DMA engine needs to
+ * know about the PrimeCell shall be passed through this struct.
+ * The DMA engine has to provide an additional function:
+ * dma_set_ambaconfig() in order for it to work with PrimeCells.
+ * @addr: this is the physical address where DMA data should be
+ * read (RX) or written (TX)
+ * @addr_width: this is the width of the source (RX) or target
+ * (TX) register where DMA data shall be read/written, in bytes.
+ * legal values: 1, 2, 4, 8.
+ * @direction: whether the data goes in or out on this channel,
+ * right now.
+ * @maxburst: the maximum number of words (note: words, not bytes)
+ * that can be sent in one burst to the device. Typically something
+ * like half the FIFO depth on I/O peripherals so you don't
+ * overflow it.
+ */
+struct amba_dma_channel_config {
+ dma_addr_t addr;
+ u8 addr_width:4;
+ enum dma_data_direction direction;
+ int maxburst;
+};
+
+/*
+ * The following are extensions to the DMA engine framework
+ * that are needed to use the engine with PrimeCells. We need
+ * to configure devices and be able to stop transfers and
+ * retrieve the number of bytes left on the channel for some
+ * RX transfers when we don't know where and how the transfer
+ * will occur.
+ */
+void dma_set_ambaconfig(struct dma_chan *chan,
+ struct amba_dma_channel_config *config);
+
+#endif /* AMBA_DMA_H */