@@ -329,15 +329,16 @@ struct vendor_data {
/**
* struct pl022 - This is the private SSP driver data structure
* @adev: AMBA device model hookup
- * @vendor: Vendor data for the IP block
- * @phybase: The physical memory where the SSP device resides
- * @virtbase: The virtual memory where the SSP is mapped
+ * @vendor: vendor data for the IP block
+ * @phybase: the physical memory where the SSP device resides
+ * @virtbase: the virtual memory where the SSP is mapped
+ * @clk: outgoing clock "SPICLK" for the SPI bus
* @master: SPI framework hookup
* @master_info: controller-specific data from machine setup
- * @regs: SSP controller register's virtual address
- * @pump_messages: Work struct for scheduling work to the workqueue
- * @lock: spinlock to syncronise access to driver data
* @workqueue: a workqueue on which any spi_message request is queued
+ * @pump_messages: work struct for scheduling work to the workqueue
+ * @queue_lock: spinlock to syncronise access to message queue
+ * @queue: message queue
* @busy: workqueue is busy
* @running: workqueue is running
* @pump_transfers: Tasklet used in Interrupt Transfer mode
@@ -348,8 +349,14 @@ struct vendor_data {
* @tx_end: end position in TX buffer to be read
* @rx: current position in RX buffer to be written
* @rx_end: end position in RX buffer to be written
- * @readingtype: the type of read currently going on
- * @writingtype: the type or write currently going on
+ * @read: the type of read currently going on
+ * @write: the type of write currently going on
+ * @exp_fifo_level: expected FIFO level
+ * @dma_rx_channel: optional channel for RX DMA
+ * @dma_tx_channel: optional channel for TX DMA
+ * @sgt_rx: scattertable for the RX transfer
+ * @sgt_tx: scattertable for the TX transfer
+ * @dummypage: a dummy page used for driving data on the bus with DMA
*/
struct pl022 {
struct amba_device *adev;
@@ -397,8 +404,8 @@ struct pl022 {
* @cpsr: Value of Clock prescale register
* @n_bytes: how many bytes(power of 2) reqd for a given data width of client
* @enable_dma: Whether to enable DMA or not
- * @write: function ptr to be used to write when doing xfer for this chip
* @read: function ptr to be used to read when doing xfer for this chip
+ * @write: function ptr to be used to write when doing xfer for this chip
* @cs_control: chip select callback provided by chip
* @xfer_type: polling/interrupt/DMA
*