[V2,1/2] spi: Add binding document for IMG SPFI controller

Commit Message

Andrew Bresticker Nov. 13, 2014, 3:08 a.m. UTC

The Synchronous Peripheral Flash Interface (SPFI) controller found
on IMG SoCs supports single, dual, and (optionally) quad mode SPI
transfers.

Signed-off-by: Andrew Bresticker <[e-mail]>
---
Changes from v1:
 - spi-img.txt -> spi-img-spfi.txt
 - fixed commit subject
---
 .../devicetree/bindings/spi/spi-img-spfi.txt       | 37 ++++++++++++++++++++++
 1 file changed, 37 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/spi/spi-img-spfi.txt

Patch

diff --git a/Documentation/devicetree/bindings/spi/spi-img-spfi.txt b/Documentation/devicetree/bindings/spi/spi-img-spfi.txt
new file mode 100644
index 0000000..c7dd50f
--- /dev/null
+++ b/Documentation/devicetree/bindings/spi/spi-img-spfi.txt
@@ -0,0 +1,37 @@ 
+IMG Synchronous Peripheral Flash Interface (SPFI) controller
+
+Required properties:
+- compatible: Must be "img,spfi".
+- reg: Must contain the base address and length of the SPFI registers.
+- interrupts: Must contain the SPFI interrupt.
+- clocks: Must contain an entry for each entry in clock-names.
+  See ../clock/clock-bindings.txt for details.
+- clock-names: Must include the following entries:
+  - spfi: SPI operating clock
+  - sys: SPI system interface clock
+- dmas: Must contain an entry for each entry in dma-names.
+  See ../dma/dma.txt for details.
+- dma-names: Must include the following entries:
+  - rx
+  - tx
+- #address-cells: Must be 1.
+- #size-cells: Must be 0.
+
+Optional properties:
+- img,supports-quad-mode: Should be set if the interface supports quad mode
+  SPI transfers.
+
+Example:
+
+spi@18100f00 {
+	compatible = "img,spfi";
+	reg = <0x18100f00 0x100>;
+	interrupts = <GIC_SHARED 22 IRQ_TYPE_LEVEL_HIGH>;
+	clocks = <&spi_clk>, <&system_clk>;
+	clock-names = "spfi", "sys";
+	dmas = <&mdc 9 0xffffffff 0>, <&mdc 10 0xffffffff 0>;
+	dma-names = "rx", "tx";
+
+	#address-cells = <1>;
+	#size-cells = <0>;
+};