@@ -30,7 +30,6 @@
/* Slave spi_dev related */
struct chip_data {
- u16 cr0;
u8 cs; /* chip select pin */
u8 n_bytes; /* current is a 1/2/4 byte op */
u8 tmode; /* TR/TO/RO/EEPROM */
@@ -291,7 +290,7 @@ static int dw_spi_transfer_one(struct spi_master *master,
u16 txlevel = 0;
u16 clk_div = 0;
u32 speed = 0;
- u32 cr0 = 0;
+ u32 cr0;
int ret;
dws->dma_mapped = 0;
@@ -306,8 +305,6 @@ static int dw_spi_transfer_one(struct spi_master *master,
spi_enable_chip(dws, 0);
- cr0 = chip->cr0;
-
/* Handle per transfer options for bpw and speed */
speed = chip->speed_hz;
if ((transfer->speed_hz != speed) || !chip->clk_div) {
@@ -328,6 +325,7 @@ static int dw_spi_transfer_one(struct spi_master *master,
dws->n_bytes = 2;
dws->dma_width = 2;
}
+ /* Default SPI mode is SCPOL = 0, SCPH = 0 */
cr0 = (transfer->bits_per_word - 1)
| (chip->type << SPI_FRF_OFFSET)
| (spi->mode << SPI_MODE_OFFSET)
@@ -449,14 +447,6 @@ static int dw_spi_setup(struct spi_device *spi)
chip->bits_per_word = spi->bits_per_word;
chip->tmode = 0; /* Tx & Rx */
- /* Default SPI mode is SCPOL = 0, SCPH = 0 */
- chip->cr0 = (chip->bits_per_word - 1)
- | (chip->type << SPI_FRF_OFFSET)
- | (spi->mode << SPI_MODE_OFFSET)
- | (chip->tmode << SPI_TMOD_OFFSET);
-
- if (spi->mode & SPI_LOOP)
- chip->cr0 |= 1 << SPI_SRL_OFFSET;
if (gpio_is_valid(spi->cs_gpio)) {
ret = gpio_direction_output(spi->cs_gpio,
Since we recalculate cr0 each time we start a transfer the chip_data->cr0 becomes redundant. Remove it and related pieces. This is a follow up to commit 0ed36990a93b (spi: dw: Remove needless if statements). Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com> --- drivers/spi/spi-dw.c | 14 ++------------ 1 file changed, 2 insertions(+), 12 deletions(-)