@@ -31,17 +31,14 @@
/* Slave spi_dev related */
struct chip_data {
u8 cs; /* chip select pin */
- u8 n_bytes; /* current is a 1/2/4 byte op */
u8 tmode; /* TR/TO/RO/EEPROM */
u8 type; /* SPI/SSP/MicroWire */
u8 poll_mode; /* 1 means use poll mode */
- u32 dma_width;
u32 rx_threshold;
u32 tx_threshold;
u8 enable_dma;
- u8 bits_per_word;
u16 clk_div; /* baud rate divider */
u32 speed_hz; /* baud rate */
void (*cs_control)(u32 command);
@@ -294,8 +291,6 @@ static int dw_spi_transfer_one(struct spi_master *master,
int ret;
dws->dma_mapped = 0;
- dws->n_bytes = chip->n_bytes;
- dws->dma_width = chip->dma_width;
dws->tx = (void *)transfer->tx_buf;
dws->tx_end = dws->tx + transfer->len;
@@ -324,6 +319,8 @@ static int dw_spi_transfer_one(struct spi_master *master,
} else if (transfer->bits_per_word == 16) {
dws->n_bytes = 2;
dws->dma_width = 2;
+ } else {
+ return -EINVAL;
}
/* Default SPI mode is SCPOL = 0, SCPH = 0 */
cr0 = (transfer->bits_per_word - 1)
@@ -437,15 +434,6 @@ static int dw_spi_setup(struct spi_device *spi)
chip->tx_threshold = 0;
}
- if (spi->bits_per_word == 8) {
- chip->n_bytes = 1;
- chip->dma_width = 1;
- } else if (spi->bits_per_word == 16) {
- chip->n_bytes = 2;
- chip->dma_width = 2;
- }
- chip->bits_per_word = spi->bits_per_word;
-
chip->tmode = 0; /* Tx & Rx */
if (gpio_is_valid(spi->cs_gpio)) {
There is no need to carry over spi->bits_per_word and Co from ->setup() in struct chip_data since ->transfer_one() will anyway take the transfer parameters from struct spi_transfer. This is since SPI core validates both bits_per_word transfer parameter and defaults to spi->bits_per_word in case that per transfer parameter is not set. Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com> --- drivers/spi/spi-dw.c | 16 ++-------------- 1 file changed, 2 insertions(+), 14 deletions(-)