@@ -9,6 +9,7 @@ Required properties:
- "fsl,imx31-cspi" for SPI compatible with the one integrated on i.MX31
- "fsl,imx35-cspi" for SPI compatible with the one integrated on i.MX35
- "fsl,imx51-ecspi" for SPI compatible with the one integrated on i.MX51
+ - "fsl,imx53-ecspi" for SPI compatible with the one integrated on i.MX53 and later Soc
- reg : Offset and length of the register set for the device
- interrupts : Should contain CSPI/eCSPI interrupt
- cs-gpios : Specifies the gpio pins to be used for chipselects.
@@ -67,7 +67,8 @@ enum spi_imx_devtype {
IMX27_CSPI,
IMX31_CSPI,
IMX35_CSPI, /* CSPI on all i.mx except above */
- IMX51_ECSPI, /* ECSPI on i.mx51 and later */
+ IMX51_ECSPI, /* ECSPI on i.mx51 */
+ IMX53_ECSPI, /* ECSPI on i.mx53 and later */
};
struct spi_imx_data;
@@ -130,6 +131,11 @@ static inline int is_imx51_ecspi(struct spi_imx_data *d)
return d->devtype_data->devtype == IMX51_ECSPI;
}
+static inline int is_imx53_ecspi(struct spi_imx_data *d)
+{
+ return d->devtype_data->devtype == IMX53_ECSPI;
+}
+
#define MXC_SPI_BUF_RX(type) \
static void spi_imx_buf_rx_##type(struct spi_imx_data *spi_imx) \
{ \
@@ -763,6 +769,17 @@ static struct spi_imx_devtype_data imx51_ecspi_devtype_data = {
.devtype = IMX51_ECSPI,
};
+static struct spi_imx_devtype_data imx53_ecspi_devtype_data = {
+ .intctrl = mx51_ecspi_intctrl,
+ .config = mx51_ecspi_config,
+ .trigger = mx51_ecspi_trigger,
+ .rx_available = mx51_ecspi_rx_available,
+ .reset = mx51_ecspi_reset,
+ .fifo_size = 64,
+ .has_dmamode = true,
+ .devtype = IMX53_ECSPI,
+};
+
static const struct platform_device_id spi_imx_devtype[] = {
{
.name = "imx1-cspi",
@@ -783,6 +800,9 @@ static const struct platform_device_id spi_imx_devtype[] = {
.name = "imx51-ecspi",
.driver_data = (kernel_ulong_t) &imx51_ecspi_devtype_data,
}, {
+ .name = "imx53-ecspi",
+ .driver_data = (kernel_ulong_t) &imx53_ecspi_devtype_data,
+ }, {
/* sentinel */
}
};
@@ -794,6 +814,7 @@ static const struct of_device_id spi_imx_dt_ids[] = {
{ .compatible = "fsl,imx31-cspi", .data = &imx31_cspi_devtype_data, },
{ .compatible = "fsl,imx35-cspi", .data = &imx35_cspi_devtype_data, },
{ .compatible = "fsl,imx51-ecspi", .data = &imx51_ecspi_devtype_data, },
+ { .compatible = "fsl,imx53-ecspi", .data = &imx53_ecspi_devtype_data, },
{ /* sentinel */ }
};
MODULE_DEVICE_TABLE(of, spi_imx_dt_ids);
@@ -1238,7 +1259,8 @@ static int spi_imx_probe(struct platform_device *pdev)
spi_imx->bitbang.master->prepare_message = spi_imx_prepare_message;
spi_imx->bitbang.master->unprepare_message = spi_imx_unprepare_message;
spi_imx->bitbang.master->mode_bits = SPI_CPOL | SPI_CPHA | SPI_CS_HIGH;
- if (is_imx35_cspi(spi_imx) || is_imx51_ecspi(spi_imx))
+ if (is_imx35_cspi(spi_imx) || is_imx51_ecspi(spi_imx) ||
+ is_imx53_ecspi(spi_imx))
spi_imx->bitbang.master->mode_bits |= SPI_LOOP | SPI_READY;
spi_imx->spi_drctl = spi_drctl;
ECSPI contorller for iMX53 and iMX6 has few hardware issues comparing to iMX51. The change add possibility to detect which controller is used to apply possible workaround and limitations. Signed-off-by: Jiada Wang <jiada_wang@mentor.com> --- .../devicetree/bindings/spi/fsl-imx-cspi.txt | 1 + drivers/spi/spi-imx.c | 26 ++++++++++++++++++++-- 2 files changed, 25 insertions(+), 2 deletions(-)