new file mode 100644
@@ -0,0 +1,36 @@
+Qualcomm Quad Serial Peripheral Interface (QSPI)
+
+The QSPI controller allows SPI protocol communication in single, dual, or quad
+wire transmission modes for read/write access to slaves such as NOR flash.
+
+Required properties:
+- compatible: An SoC specific identifier followed by "qcom,qspi-v1", such as
+ "qcom,sdm845-qspi", "qcom,qspi-v1"
+- reg: Should contain the base register location and length.
+- interrupts: Interrupt number used by the controller.
+- clocks: Should contain the core and AHB clock.
+- clock-names: Should be "core" for core clock and "iface" for AHB clock.
+
+SPI slave nodes must be children of the SPI master node and can contain
+properties described in Documentation/devicetree/bindings/spi/spi-bus.txt
+
+Example:
+
+ qspi: spi@88df000 {
+ compatible = "qcom,sdm845-qspi", "qcom,qspi-v1";
+ reg = <0x88df000 0x600>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+ interrupts = <GIC_SPI 82 IRQ_TYPE_LEVEL_HIGH>;
+ clock-names = "iface", "core";
+ clocks = <&gcc GCC_QSPI_CNOC_PERIPH_AHB_CLK>,
+ <&gcc GCC_QSPI_CORE_CLK>;
+
+ flash@0 {
+ compatible = "jedec,spi-nor";
+ reg = <0>;
+ spi-max-frequency = <25000000>;
+ spi-tx-bus-width = <2>;
+ spi-rx-bus-width = <2>;
+ };
+ };