spi: pxa2xx: Balance runtime PM enable/disable on error

Commit Message

Lubomir Rintel July 19, 2019, 12:27 p.m. UTC

Don't undo the PM initialization if we error out before we managed to
initialize it. The call to pm_runtime_disable() without being preceded
by pm_runtime_enable() would disturb the balance of the Force.

In practice, this happens if we fail to allocate any of the GPIOS ("cs",
"ready") due to -EPROBE_DEFER because we're getting probled before the
GPIO driver.

Signed-off-by: Lubomir Rintel <[e-mail]>
---
 drivers/spi/spi-pxa2xx.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

Patch

diff --git a/drivers/spi/spi-pxa2xx.c b/drivers/spi/spi-pxa2xx.c
index fc7ab4b268802..22513caf20006 100644
--- a/drivers/spi/spi-pxa2xx.c
+++ b/drivers/spi/spi-pxa2xx.c
@@ -1831,14 +1831,16 @@  static int pxa2xx_spi_probe(struct platform_device *pdev)
 	status = devm_spi_register_controller(&pdev->dev, controller);
 	if (status != 0) {
 		dev_err(&pdev->dev, "problem registering spi controller\n");
-		goto out_error_clock_enabled;
+		goto out_error_pm_runtime_enabled;
 	}
 
 	return status;
 
-out_error_clock_enabled:
+out_error_pm_runtime_enabled:
 	pm_runtime_put_noidle(&pdev->dev);
 	pm_runtime_disable(&pdev->dev);
+
+out_error_clock_enabled:
 	clk_disable_unprepare(ssp->clk);
 
 out_error_dma_irq_alloc: