@@ -14,6 +14,7 @@
aliases {
ethernet0 = &emac;
serial0 = &uart0;
+ spi0 = &spi0;
};
chosen {
@@ -278,6 +279,24 @@
vcc-pm-supply = <®_aldo1>;
};
+/*
+ * The CS pin is shared with the MMC2 CMD pin, so we cannot have the SPI
+ * flash and eMMC at the same time, as one of them would fail probing.
+ * Disable SPI0 in here, to prefer the more useful eMMC. U-Boot can
+ * fix this up in no eMMC is connected.
+ */
+&spi0 {
+ pinctrl-0 = <&spi0_pins>, <&spi0_cs_pin>;
+ pinctrl-names = "default";
+ status = "disabled";
+
+ flash@0 {
+ compatible = "winbond,w25q128", "jedec,spi-nor";
+ reg = <0>;
+ spi-max-frequency = <4000000>;
+ };
+};
+
&uart0 {
pinctrl-names = "default";
pinctrl-0 = <&uart0_ph_pins>;
The Pine H64 board comes with SPI flash soldered on the board, connected to the SPI0 pins (so it can also boot from there). Add the required SPI flash DT node to describe this. Unfortunately the SPI CS0 pin collides with the eMMC CMD pin, so we can't use both eMMC and SPI flash at the same time (the first to claim the pin would win, the other's probe routine would then fail). To avoid losing the more useful eMMC device by chance, mark the SPI device as "disabled" for now. A user or some U-Boot code could fix this up if needed, for instance if no eMMC has been detected (it's socketed). Signed-off-by: Andre Przywara <andre.przywara@arm.com> --- arch/arm64/boot/dts/allwinner/sun50i-h6-pine-h64.dts | 19 +++++++++++++++++++ 1 file changed, 19 insertions(+)