| Message ID | 20221117105249.115649-8-tudor.ambarus@microchip.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
| Series | spi: Introduce spi-cs-setup-ns dt property | expand |
diff --git a/arch/arm/boot/dts/at91-sama5d2_icp.dts b/arch/arm/boot/dts/at91-sama5d2_icp.dts index dd1dec9d4e07..ffd9627874c9 100644 --- a/arch/arm/boot/dts/at91-sama5d2_icp.dts +++ b/arch/arm/boot/dts/at91-sama5d2_icp.dts @@ -669,7 +669,8 @@ flash@0 { #size-cells = <1>; compatible = "jedec,spi-nor"; reg = <0>; - spi-max-frequency = <80000000>; + spi-max-frequency = <104000000>; + spi-cs-setup-ns = /bits/ 16 <7>; spi-tx-bus-width = <4>; spi-rx-bus-width = <4>; m25p,fast-read;
sama5d2_icp populates an sst26vf064b SPI NOR flash. Its maximum operating frequency for 2.7-3.6V is 104 MHz. As the flash is operated at 3.3V, increase its maximum supported frequency to 104MHz. The increasing of the spi-max-frequency value requires the setting of the "CE# Not Active Hold Time", thus set the spi-cs-setup-ns to a value of 7. The sst26vf064b datasheet specifies just a minimum value for the "CE# Not Active Hold Time" and it advertises it to 5 ns. There's no maximum time specified. I determined experimentally that 5 ns for the spi-cs-setup-ns is not enough when the flash is operated close to its maximum frequency and tests showed that 7 ns is just fine, so set the spi-cs-setup-ns dt property to 7. With the increase of frequency the reads are now faster with ~37%. Signed-off-by: Tudor Ambarus <tudor.ambarus@microchip.com> --- arch/arm/boot/dts/at91-sama5d2_icp.dts | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)