new file mode 100644
@@ -0,0 +1,24 @@
+Required properties:
+- compatible: should be one of the following
+ "st,st33htpm-spi"
+ "infineon,slb9670"
+ "tcg,tpm_tis-spi"
+- spi-max-frequency: Maximum SPI frequency (depends on TPMs).
+
+Optional SoC Specific Properties:
+- pinctrl-names: Contains only one value - "default".
+- pintctrl-0: Specifies the pin control groups used for this controller.
+
+Example (for ARM-based BeagleBoard xM with TPM_TIS on SPI4):
+
+&mcspi4 {
+
+ status = "okay";
+
+ tpm_tis@0 {
+
+ compatible = "tcg,tpm_tis-spi";
+
+ spi-max-frequency = <10000000>;
+ };
+};
@@ -41,6 +41,18 @@ config TCG_TIS
within Linux. To compile this driver as a module, choose M here;
the module will be called tpm_tis.
+config TCG_TIS_SPI
+ tristate "TPM Interface Specification 1.3 Interface / TPM 2.0 FIFO Interface - (SPI)"
+ depends on SPI
+ select TCG_TIS_CORE
+ ---help---
+ If you have a TPM security chip which is connected to a regular,
+ non-tcg SPI master (i.e. most embedded platforms) that is compliant with the
+ TCG TIS 1.3 TPM specification (TPM1.2) or the TCG PTP FIFO
+ specification (TPM2.0) say Yes and it will be accessible from
+ within Linux. To compile this driver as a module, choose M here;
+ the module will be called tpm_tis_spi.
+
config TCG_TIS_I2C_ATMEL
tristate "TPM Interface Specification 1.2 Interface (I2C - Atmel)"
depends on I2C
@@ -14,6 +14,7 @@ endif
endif
obj-$(CONFIG_TCG_TIS_CORE) += tpm_tis_core.o
obj-$(CONFIG_TCG_TIS) += tpm_tis.o
+obj-$(CONFIG_TCG_TIS_SPI) += tpm_tis_spi.o
obj-$(CONFIG_TCG_TIS_I2C_ATMEL) += tpm_i2c_atmel.o
obj-$(CONFIG_TCG_TIS_I2C_INFINEON) += tpm_i2c_infineon.o
obj-$(CONFIG_TCG_TIS_I2C_NUVOTON) += tpm_i2c_nuvoton.o
new file mode 100644
@@ -0,0 +1,245 @@
+/*
+ * Copyright (C) 2015 Infineon Technologies AG
+ * Copyright (C) 2016 STMicroelectronics SAS
+ *
+ * Authors:
+ * Peter Huewe <peter.huewe@infineon.com>
+ * Christophe Ricard <christophe-h.ricard@st.com>
+ *
+ * Maintained by: <tpmdd-devel@lists.sourceforge.net>
+ *
+ * Device driver for TCG/TCPA TPM (trusted platform module).
+ * Specifications at www.trustedcomputinggroup.org
+ *
+ * This device driver implements the TPM interface as defined in
+ * the TCG TPM Interface Spec version 1.3, revision 27 via _raw/native
+ * SPI access_.
+ *
+ * It is based on the original tpm_tis device driver from Leendert van
+ * Dorn and Kyleen Hall and Jarko Sakkinnen.
+ *
+ * This program is free software; you can redistribute it and/or
+ * modify it under the terms of the GNU General Public License as
+ * published by the Free Software Foundation, version 2 of the
+ * License.
+ */
+
+#include <linux/init.h>
+#include <linux/module.h>
+#include <linux/moduleparam.h>
+#include <linux/slab.h>
+#include <linux/interrupt.h>
+#include <linux/wait.h>
+#include <linux/acpi.h>
+#include <linux/freezer.h>
+
+#include <linux/module.h>
+#include <linux/spi/spi.h>
+#include <linux/gpio.h>
+#include <linux/of_irq.h>
+#include <linux/of_gpio.h>
+#include <linux/tpm.h>
+#include "tpm.h"
+#include "tpm_tis_core.h"
+
+#define MAX_SPI_FRAMESIZE 64
+
+struct tpm_tis_spi_phy {
+ struct tpm_tis_data priv;
+ struct spi_device *spi_device;
+
+ u8 tx_buf[MAX_SPI_FRAMESIZE + 4];
+ u8 rx_buf[MAX_SPI_FRAMESIZE + 4];
+};
+
+struct tpm_tis_spi_phy *to_tpm_tis_spi_phy(struct tpm_tis_data *data)
+{
+ return container_of(data, struct tpm_tis_spi_phy, priv);
+}
+
+static int tpm_tis_spi_read_bytes(struct tpm_tis_data *data, u32 addr,
+ u16 len, u8 *result)
+{
+ struct tpm_tis_spi_phy *phy = to_tpm_tis_spi_phy(data);
+ int ret, i;
+ struct spi_message m;
+ struct spi_transfer spi_xfer = {
+ .tx_buf = phy->tx_buf,
+ .rx_buf = phy->rx_buf,
+ .len = 4,
+ };
+
+ if (len > MAX_SPI_FRAMESIZE)
+ return -ENOMEM;
+
+ phy->tx_buf[0] = 0x80 | (len - 1);
+ phy->tx_buf[1] = 0xd4;
+ phy->tx_buf[2] = (addr >> 8) & 0xFF;
+ phy->tx_buf[3] = addr & 0xFF;
+
+ spi_xfer.cs_change = 1;
+ spi_message_init(&m);
+ spi_message_add_tail(&spi_xfer, &m);
+
+ spi_bus_lock(phy->spi_device->master);
+ ret = spi_sync_locked(phy->spi_device, &m);
+ if (ret < 0)
+ goto exit;
+
+ memset(phy->tx_buf, 0, len);
+
+ /* According to TCG PTP specification, if there is no TPM present at
+ * all, then the design has a weak pull-up on MISO. If a TPM is not
+ * present, a pull-up on MISO means that the SB controller sees a 1,
+ * and will latch in 0xFF on the read.
+ */
+ for (i = 0; (phy->rx_buf[0] & 0x01) == 0 && i < TPM_RETRY; i++) {
+ spi_xfer.len = 1;
+ spi_message_init(&m);
+ spi_message_add_tail(&spi_xfer, &m);
+ ret = spi_sync_locked(phy->spi_device, &m);
+ if (ret < 0)
+ goto exit;
+ }
+
+ spi_xfer.cs_change = 0;
+ spi_xfer.len = len;
+ spi_xfer.rx_buf = result;
+
+ spi_message_init(&m);
+ spi_message_add_tail(&spi_xfer, &m);
+ ret = spi_sync_locked(phy->spi_device, &m);
+
+exit:
+ spi_bus_unlock(phy->spi_device->master);
+ return ret;
+}
+
+static int tpm_tis_spi_write_bytes(struct tpm_tis_data *data, u32 addr,
+ u16 len, u8 *value)
+{
+ struct tpm_tis_spi_phy *phy = to_tpm_tis_spi_phy(data);
+ int ret, i;
+ struct spi_message m;
+ struct spi_transfer spi_xfer = {
+ .tx_buf = phy->tx_buf,
+ .rx_buf = phy->rx_buf,
+ .len = 4,
+ };
+
+ if (len > MAX_SPI_FRAMESIZE)
+ return -ENOMEM;
+
+ phy->tx_buf[0] = len - 1;
+ phy->tx_buf[1] = 0xd4;
+ phy->tx_buf[2] = (addr >> 8) & 0xFF;
+ phy->tx_buf[3] = addr & 0xFF;
+
+ spi_xfer.cs_change = 1;
+ spi_message_init(&m);
+ spi_message_add_tail(&spi_xfer, &m);
+
+ spi_bus_lock(phy->spi_device->master);
+ ret = spi_sync_locked(phy->spi_device, &m);
+ if (ret < 0)
+ goto exit;
+
+ memset(phy->tx_buf, 0, len);
+
+ /* According to TCG PTP specification, if there is no TPM present at
+ * all, then the design has a weak pull-up on MISO. If a TPM is not
+ * present, a pull-up on MISO means that the SB controller sees a 1,
+ * and will latch in 0xFF on the read.
+ */
+ for (i = 0; (phy->rx_buf[0] & 0x01) == 0 && i < TPM_RETRY; i++) {
+ spi_xfer.len = 1;
+ spi_message_init(&m);
+ spi_message_add_tail(&spi_xfer, &m);
+ ret = spi_sync_locked(phy->spi_device, &m);
+ if (ret < 0)
+ goto exit;
+ }
+
+ spi_xfer.len = len;
+ spi_xfer.tx_buf = value;
+ spi_xfer.cs_change = 0;
+ spi_xfer.tx_buf = value;
+ spi_message_init(&m);
+ spi_message_add_tail(&spi_xfer, &m);
+ ret = spi_sync_locked(phy->spi_device, &m);
+
+exit:
+ spi_bus_unlock(phy->spi_device->master);
+ return ret;
+}
+
+static const struct tpm_tis_phy_ops tpm_spi_phy_ops = {
+ .read_bytes = tpm_tis_spi_read_bytes,
+ .write_bytes = tpm_tis_spi_write_bytes,
+ .read16 = tpm_tis_common_read16,
+ .read32 = tpm_tis_common_read32,
+ .write32 = tpm_tis_common_write32,
+};
+
+static int tpm_tis_spi_probe(struct spi_device *dev)
+{
+ struct tpm_tis_spi_phy *phy;
+
+ phy = devm_kzalloc(&dev->dev, sizeof(struct tpm_tis_spi_phy),
+ GFP_KERNEL);
+ if (!phy)
+ return -ENOMEM;
+
+ phy->spi_device = dev;
+
+ return tpm_tis_core_init(&dev->dev, &phy->priv, -1, &tpm_spi_phy_ops,
+ NULL);
+}
+
+static SIMPLE_DEV_PM_OPS(tpm_tis_pm, tpm_pm_suspend, tpm_tis_resume);
+
+static int tpm_tis_spi_remove(struct spi_device *dev)
+{
+ struct tpm_chip *chip = spi_get_drvdata(dev);
+
+ tpm_chip_unregister(chip);
+ tpm_tis_remove(chip);
+ return 0;
+}
+
+static const struct spi_device_id tpm_tis_spi_id[] = {
+ {"tpm_tis_spi", 0},
+ {}
+};
+MODULE_DEVICE_TABLE(spi, tpm_tis_spi_id);
+
+static const struct of_device_id of_tis_spi_match[] = {
+ { .compatible = "st,st33htpm-spi", },
+ { .compatible = "infineon,slb9670", },
+ { .compatible = "tcg,tpm_tis-spi", },
+ {}
+};
+MODULE_DEVICE_TABLE(of, of_tis_spi_match);
+
+static const struct acpi_device_id acpi_tis_spi_match[] = {
+ {"SMO0768", 0},
+ {}
+};
+MODULE_DEVICE_TABLE(acpi, acpi_tis_spi_match);
+
+static struct spi_driver tpm_tis_spi_driver = {
+ .driver = {
+ .owner = THIS_MODULE,
+ .name = "tpm_tis_spi",
+ .pm = &tpm_tis_pm,
+ .of_match_table = of_match_ptr(of_tis_spi_match),
+ .acpi_match_table = ACPI_PTR(acpi_tis_spi_match),
+ },
+ .probe = tpm_tis_spi_probe,
+ .remove = tpm_tis_spi_remove,
+ .id_table = tpm_tis_spi_id,
+};
+module_spi_driver(tpm_tis_spi_driver);
+
+MODULE_DESCRIPTION("TPM Driver for native SPI access");
+MODULE_LICENSE("GPL");